I have an issue with a Precision 500D table that when rotated will stop after 3 degree's, then you have to press rotate again and it will go another 3 degree's ....etc. G.E. came in the last time and apparently took the table off the mount and did something then re-installed it....anyone ever have this problem before because I've never seen it.
Tue Sep 22 2015
Table only rotates in 3 degree increments
Wed Sep 23 2015Reply from Frankie B.
Wed Sep 23 2015Reply from xrayxpert
Apparently G.E. was at this site about a month ago with the same problem. The engineer said the table was not installed correctly and from what I understand from my conversation with the Director of Radiology is that they jacked up and dis-assembled the table and then put it back together. ???? G.E. originally installed the table yet they charged this customer $12,000 for this repair.....I have asked for the service report to see exactly what they did and if any parts were involved but have yet to receive it. Has anyone heard of anything like this because it's a new one to me!
Report Post