Sun Jul 10 2016

Errors 200 & 203

After power on, displayed two error messages: Error 200 - "Defective energy shutdown"... Error 203 "Defective pulse shutdown". I can't find the error list or service manual. Can You explain me what I must check? And what can do with this problem with nyself.


   RE: Surgical Laser Report Post
Sun Oct 14 2018Reply from visualmed
avatar placemark

Hi

You need upgrade the laser up to ver. 2.17

 

Thanks

 

Ángel Blanco


Report Post
Sat Feb 29 2020Reply from Shashikant
avatar placemark

Facing the same issues. After turning on 200 ,or 203 error appears on screen.

Please let me know the Solution 


Report Post
Sat Feb 29 2020Reply from visualmed
avatar placemark

error 203 is when the cavity is at the end of life, check the hours of the laser and the shots , if you have many you have to change the cavity

Regards


Report Post
Sat Feb 29 2020Reply from Shashikant
avatar placemark

Thanks for valuable information. and glad to know reason 

Following message appeared on screen 

Error 200

Defective energy shutdown. 

After turning off and on again and again (3 times). It becomes ready...

Please  help solve the problems

Some times error  203 that  was already replied..

Thanking you 

Shashikant shinde


Report Post
Sun Mar 01 2020Reply from visualmed
avatar placemark

Hi,

 

Pusch INFO KEY and let me know laser hours, you can measure the otput power with power meter, swicht on the Yag laser select max power mode 1 , measure the power , if the power under 8 mJ you need change the cavity

 

Regards

 


Report Post
Tue Mar 03 2020Reply from Shashikant
avatar placemark

Thanks for replay

Working time 413 hours.

Version 2.1.3 

Please let me know how to change the cavity. 

Its location and place.also how to upgrade the version.

 

Please help me solve this issue

Thanks 

Shashikant Shinde 


Report Post
Wed Mar 04 2020Reply from visualmed
avatar placemark

You need new cavity, special tool to adjust, PCMACIA with software version 2.17

and power meter

i am from Spain


Report Post
Thu Mar 05 2020Reply from luvmedi
avatar placemark

Repalce miniLaser head then calibrate the power, aim beam too.


Report Post
Thu Mar 05 2020Reply from Shashikant
avatar placemark

Pivotal guidance is helpful to solve the issue. 

If any service support is required then please guide us.

Thanks 

Shashikant Shinde 


Report Post

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Please review our Privacy Policy for more details.
I Agree