Hi,
I own a Fluke prosim 8, while trying to automate the controls i've a challenge in stop data for SpO2 for say 10 Seconds and bring it up after a while for performing this action is there any controls to either stop flushing SpO2 data or to put prosim to sleep and bring it up after a duration?
Hi Pradz,
I spoke with my contact at Fluke concerning your question. Here was his repsonse:
"There is no way to put the ProSim 8 asleep when using the ProSim 8 with the SpO2 Test Module as a stand-alone SpO2 functional tester. I have also taken a look at the Ansur Automation Software and there is also no provision to set a delay before the ProSim 8 starts the SpO2 “simulation”.
It is a new feature that could be investigated the next time the Ansur Software and/or ProSim 8 firmware is upgraded."
You can speak with John at Fluke directly by contacting him at john.shirlock@fluke.com
You are most welcome, Pradz.
Do you only use the ansur as interface?
e.g if you use Labview for automation you can easyls create delays bevor measurement
Hi,
We are just sending commands via COM port from a java framework.
Right now we are using the self test command from prosim to ensure this data inactivity.
