C-Scanner cannot detect image properly

First, if you loose power, you need to keep the scanner on 1 hour for every hour that was off up to 8 hours. Leave it on for ovenight. Second , does it happens with every coil?

yes..all the coils the same problem.. the image does not show up during scouting and I have already turn it ON over 8 hours..still cannot detect image. I  suspect the problem got relation to the magnet coz the command keep repeating incorrect temperature.

Have you done the Temp Check , Temp Monitor ? also the TPM LED are they ok? a,b,c,d,e, on and f blinking?

Can I know how to check all those on MRI? I am new student here and I don't know how the previous person countermeasure these problems, all I have right now is only the User Manual. Also, I have googled to search online maintenance and troubleshooting manuals for this type of MRI and failed to get one.

where can I get the services password? There were no LED's that blinking ON and OFF..our unit does not hv any blinking LED's

I got your response , but is not showing here. you need to check the 5 volt supply inside the TPM

it shows frequency error and said to check the rec files. What does this means??

I have checked the REC Files. Magnet UP Heater temperature shows out of range value with magnet power = 0 value. How to solve this problem?

REC Files shows error in magnet temperature and power. The magnet power becomes 0 for all the magnets