I have a bv pulsera that will not boot up. The c-arm will boot up with an error code of M050. When disconnected the workstation will not boot I get two hourglasses and it does not advance. Anyone have any ideas?
Fri Sep 27 2013
BV pulsera/hourglass not booting
Sun Sep 29 2013Reply from www.PI.solutions
Sorry, must have missed this one. I don't have my laptop with me with error code explanations but it sounds like a DFI failure. Could just need a software reload or possible hardware problem. You could try disconnecting peripherals and bring it up.
Jamison Ashby, MBA
Owner: Precision Imaging solutions
www.PI.solutions
Report Post
Mon Sep 30 2013Reply from www.PI.solutions
It could aslo be the umbilical cable. Block imaging has these but make sure you get a new one.
Jamison Ashby, MBA
Owner: Precision Imaging solutions
www.PI.solutions
Report Post
Mon Sep 30 2013Reply from chris?
with the monitor cart disconnected the monitor cart should boot up by itself mostly the software or the hard drive is the problem you will need to take the front cover off to tell what DFI verision you have let me know if you need help crisb1955@aol.com
Report Post
