Forums

39487 Results
Added  Mar 29 2024
0 Replies

I have a fleet of 1105s and a few other similar Stryker stretchers, when pumping the bed up they have become hard to pump. They will o up just the amount of force required to push down the pedal is increasing. I have lowered the beds and checked fluids and they leak as soon as I pull the plug so I don't see a leak issue (no leaks found n the cylinders) Is it necessary to remove the top to check the cylinders? I know its easier with the top off but I'm a one man shop s top removal is tough. 

Fluids levels look good.

No leaks detected on hydraulic. 

No binding in the pedal assembly's. 

If it was just 1 or 2 units I would replace the cylinders but it seems to be happening to a lot of them so I must be missing something. 

Thanks For any assist.

Equipment: Stryker 1105 Stretcher and more

Added  Mar 29 2024
0 Replies

CALIBRATION

Equipment: MEDRONIC ACT PLUS

0 Replies

Hello everyone,

I need to enter in the service menu of Braun Compact Plus perfusor pump, is there anyone who happens to know the code for entering in this service menu?

Thanks for your help!

Equipment: Braun Perfusor Compact Plus

Added  Mar 29 2024
0 Replies

Hi, my table position does not go to the center when I press the center button. That's why QC has not started.

Equipment: Hologic discovery Wi

Added  Mar 28 2024
0 Replies

I have a problem 84 and 79 on a Lyra - can anyone help me solve that problem please - Thank you 

RE: IRIDEX - Laserscope Lyra-i
1 Reply

Can you leave a item in the sterrad NX over night?

Equipment: Starred NX

1 Reply

Hello,

Am looking for a used Whale 15L5V Linear Probe.

Thank you


Joseph 


Equipment: Whale Sigma P5 Ultrasound

Updated  Mar 28 2024
2 Replies

Instrucciones

Equipment: Baxter - AK 98

RE: Baxter - AK 98
0 Replies

Hi all,


I have a xenon nova 175 Karl Storz light source which had a lamp that had run up its working hour. After i replaced the xenon lamp the light came on for a moment, but after that the lamp and the heat sink just make this continious clicking sound and no light is shown from the lamp.


The fan and all other components seems fuctional but lamp will not turn on and makes this continious clicking sounds.


Any help is appreciated

Equipment: Xenon nova 175 Model 20131520

Added  Mar 28 2024
0 Replies

Hi

Need help on Sm Century 400 with door unsealed alarm. Exhaust and steam manifold have been changed twice. CK1/2 and 14 also have been changed. PRV, door pressure switch also change and calibrated. After starting DART test not even 5 minutes after the seal got activated the error shows up door unsealed alarm. Im struggling to get it resolve and run out of option hence reaching out here for help. 

Equipment: Amsco 400 small

Ask a Question

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Please review our Privacy Policy for more details.
I Agree