- All Categories
- Surgical
- Anesthesia Equipment
- Aspirator
- Autotransfusion Unit
- Biopsy
- Blood Warmer
- Corneal Topography System
- Cryosurgical Units
- Diathermy Unit
- Electrosurgical Unit (ESU)
- Endoscopy
- Fluid Management Systems
- Image-Guided Surgery System
- Lesion Generator
- Microscope-Surgical
- Patient Positioners
- Phacoemulsification Unit
- Radiosurgery
- Smoke Evacuation System
- Surgical Head Lights
- Surgical Light
- Surgical Slush Machines
- Surgical Table
- Tourniquets
- Waste Management System
Surgical Light Forums
Add Surgical Light to My Bench273 Results
Added Jan 23 2024
0 Replies
Hi there.Do you have a service manual for an Amsco Polaris light?
Equipment: Amsco polaris light
RE: STERIS - AMSCO PolarisAdded Dec 28 2023
0 Replies
How do you get into calibration mode, steris will only tell me I have to call in a steris tech.....so much for the right to repair...
RE: STERIS - Harmony LEDUpdated Dec 17 2023
1 ReplyHow to tight to prevent light/camera head drift
Equipment: Service manual
RE: Skytron - Aurora IIUpdated Oct 3 2023
1 ReplyI have purchased this twin arm light but it has no ceiling fixing bracket. Can I purchase it. Can I get a manual on one of these
Equipment: Alm X-ten ceiling mounted light
RE: MAQUET - ALM-X'TENUpdated Jul 17 2023
1 Reply
Light not turning on flashing light on control panel. We have changed out the light bulb and still nothing, when we turn on the light we get no light, and the light bulb icon on the energix control panel just flashes after about 10 seconds.
Equipment: Maquet Prismalix
RE: MAQUET - PrismalixUpdated Apr 3 2023
Updated Mar 29 2023
2 RepliesMy problem started about 3 months ago. I get a call that the dual light in one of my OR rooms is acting funny. When the light powers on it starts in the number 3 intensity, then after a couple seconds it jumps both touch pads back to 0. Once it does it the first time and you put it on the desired intensity level, it stays until the power is cycled again. So 3 months when trouble shooting I noticed if I unplugged the #1 light from the shared board, the #2 light started working like it was supposed to. I changed both boards and finally found the touch pad on the #1 light was causing the issue, but I’m still not sure how. It worked fine for 3 months. Now the #1 light has started doing the same thing again. I replaced both boards and touch pad with no results. I’m wondering if anyone else has I countered this problem as tech support says they have not. Thanks for any help. RE: Skytron - Aurora 3
Updated Mar 24 2023
1 ReplyThe 40K hr indicator light is on for my Aurora 3 lights. Is there a way to reset it? RE: Skytron - Aurora 3
Updated Mar 11 2023
1 ReplyI am trying to find the service manual for this surgical light and cannot find it, I am trying to find out of the light has higher settings and how to use them.
Thanks
Michelle
Equipment: medical illumination Centurion
RE: Medical Illumination - CenturionUpdated Jan 30 2023
3 RepliesMay I have the part number for the "parallel compensation rod?" Please and thank you.
Equipment: Berchtold - Chromophare F 628
RE: Berchtold - Chromophare F 628