Sorin Group - 3T Heater-Cooler System
DESCRIPTION
The Stöckert Heater-Cooler System 3T provides fast and efficient heating and cooling, independent of the ice and water supply in the operating room.
Three water tanks provide separate settings for warm cardioplegia, cold cardioplegia and patient temperature. Patient temperature settings can be adjusted to the tenth decimal point for accurate temperature control. Furthermore, water in the lines can be pulled back into the tanks at the end of the case to facilitate cleanup.
FORUMSView All (26)
1Reply3 months ago | Error EE23 Dear sir this error mean an problem by the pump ...i replaced the pump with the same part but the problem is ...new pump hase tow wire ...old one hase 3 wire ...how i can solve this problem please Reply |
2Replies2 years ago | No power My unit will not start up. The fuse on the power distribution board is in tact. Where else should I look?Reply |
1Reply3 years ago | What is errorEE4 What is error. Code EE4Reply |
DOCUMENTS / MANUALSView All
SERVICE COMPANIESView All Warming/Cooling Unit Companies
FEATURES
- Extremely short pre-cooling times due to the small volume of the tank
- Separate tanks enable switching between warm and cold cardioplegia without delay
- Cooling with the ice container is not necessary during routine operation due to the strong performance of the compressor assembly
- An independent safety system prevents the water temperature from reaching critical values
- The two-chamber pumps minimize any pressure inside the heat exchanger
- The suction stage of the pumps enables a smooth emptying of the heat exchanger and the tubing
Height | 33.2 in |
Length | 26.8 in |
Weight | 228.5 lbs |
Width | 19.8 in |
FDA AlertsView All
Class 1 Recall: Mycobacterium chimaera Infections Associated...
The FDA is providing new information about Mycobacterium chimaera (M. chimaera) infections associated with the use of the 3T in patients who have undergone cardiothoracic surgeries.