Valleylab - SSE2L
Valleylab SSE2L Forums
Updated Aug 18 2021
1 ReplyHi there. I have a sse2l and the problem is when i turn on the machine the isobloc board R1 resistor got burned. What is the cause of burned resistor in isobloc?
I already isolate the isobloc board and where the output supply came but all the components seems good and no suspicious etc.
Please i need help thanks in advance... RE: Valleylab - SSE2L
Updated Dec 23 2020
1 ReplyLa manche fonctionne bien mais la coagulation et la coupure ne fonctionne pas. Tout les fusible marche. aidez moi Svp RE: Valleylab - SSE2L
Updated Nov 4 2020
1 ReplyGood Afternoon,
My office needs to know which grounding pads are compatible with the above listed device. Please advise.
Thank you.
Pattie RE: Valleylab - SSE2L
Updated Nov 3 2017
3 RepliesDoes anyone know if you can get the plastic casing that the patient input is housed? Its a smoked colored plastic and I have one that is crumbling / deteriorated. The unit works fine . RE: Valleylab - SSE2L
Added Nov 26 2016
0 Replies
the beeb sound is to loud .cannot be adjust by control .i check the potentiometer control ,its ok
what is the problem
RE: Valleylab - SSE2LUpdated Aug 31 2015
Added Jun 1 2015
Updated Nov 19 2014
Added Nov 19 2014
Added Mar 5 2013
0 Replies
When I turn the power switch on with bipolar footswitch selected, I get a rem alarm. Is this normal; I didn't think a return pad was required in bipolar mode and Valleylab/Covidien no longer supports this unit.
RE: Valleylab - SSE2L