Sorvall - RC5C+
by Sorvall

Follow Us
DESCRIPTION
Refrigerated, floor model centrifuge

RC5C+ Refrigerated, floor model centrifuge, speeds from 50 to 21000rpm

FORUMSView All (13)
Ask a New Question

1

Reply
-Zinda Dayal
3 years ago
Replacement Brush Part#
In my Centrifuge operating Instruction it says the replacement brush catalogue# is 12284. Service centre expert says another brush with Catalogue# 74196. Which one is the right replacement brush kit. Please help. Reply

0

Replies
-The Man
3 years ago
Source of Spares - Dublin/Ireland
Hi, newbie here. Wonder if anyone can help with sources of spares for the Sorval RC-5C+. For the Brushed motor, looking at either.. - New rotor (commutators are worn +- 1mm). - New motor. The motor has no ID plates etc.., except for a number stamped on it - 3995 ThanksReply

5

Replies
-PaceDx
5 years ago
Error #4 flashing, Spin spindle no longer work
Hello All, I have a #4 fault error flashing yesterday where the centrifuge stopped after 9 minutes into the set spin time (of 35 minutes). Observed an out of range temperature on the dash board (18-24deg) and it shut down itself. The spin head spindle (where the rotor insert in) appeared to stop spinning but the refrigerated unit was still working fine (still got cold). We had a brush replacement 6 months ago and we used very little work on this machine. We thought might be the bearing got lock up but not sure what cause. Any ideas this Error #4 means? We then turned off the power, turned on the centrifuge 4 hours later, the #4 message was gone. We then tested the rotor at 200rpm but it still not spin. Any idea what the cause? Thanks in advance. Victoria Reply
DOCUMENTS / MANUALSView All
SERVICE COMPANIESView All Centrifuge Companies

SPECIFICATIONS

OrientationFloor Standing
Maximum Speed21000 rpm
This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Please review our Privacy Policy for more details.
I Agree