Digital Mammography: Hologic MG Products: Affirm Biopsy, SecurView DX, R2 Cenova CAD, and ATEC Sapphire
Students will learn how to perform system maintenance procedures including, system install, configurations and adjustments, software load, including hardware configuration, quality control checks/tests and more.
Start Date:
End Date:
Overview
This Hologic Mammography Products training course will provide engineers the necessary knowledge to maintain systems that interface with the Hologic Dimensions 2D or 3D Tomo, and the Hologic Selenia 2D systems. Given today’s regulatory environment maintaining the system at peak performance is of the utmost importance.
At the completion of this course students will be able to perform system maintenance procedures including:
- System install
- Configurations and adjustments
- Software load, including necessary hardware configuration
- Quality Control Checks/Tests
- Preventive Maintenance
- Troubleshooting
Systems covered in this training class include:
- Affirm Biopsy (Upright)
- SecurView DX Diagnostic Workstation
- R2 Cenova CAD
- ATEC Sapphire Vacuum Module
Prerequisites
To attend this course, the service professional must have attended Phase I and possess fundamental knowledge and understanding of the principles of X-ray and basic electronics. Students must have also attended either RSTI’s Hologic Dimensions 3D Tomo Mammo or
RSTI’s Selenia 2D training courses.
Objectives
(For each product)
- Identify the major components of the system
- Complete all operator, administration, and application tasks
- Configure the system to interface with related components
- Perform all checks and adjustments to maintain compliance with QC/MQSA requirements
- Demonstrate competence to be able to handle maintenance, backup, restore, and software load from cold (where applicable)
- Perform complete Preventive Maintenance procedures as performed by the OEM
- Evaluate circuit functions to facilitate troubleshooting