Good Morning, I am trying to get a quote on a warmette. Would you be able to assist me with that? I am an Employee at the San Francisco VAMC an would like to purchase if possible. It would be great if you can get back with me at your earliest convenience .
Not sure if we still have a contract. It's been a while since we've purchased.
Thank you,
April Johnson-HIll
Equipment: Olympic Medical - Warmette Model 10 and 20
I am trying to prepare two generation I machines (2012, 2014) for resale and require the cycle count so that the buyer will be able to predict the next PM. I assume the cycles should be info that can be viewed using sequenced keying on bootup, but there are no directions in the user manual and nothing I have tried has worked so far. The boot up initial display shows only S/N and software info. Both machines pass their self texts and proceed into the purge cycle where they continue unless powered down. Both seem to complete an initial stage of purging after about 15 minutes and then shift into something pretty much the same after a couple of seconds of what sounds like electronic switching.
What I would like is:
* directions for the cycle recall sequence or whatever process is required to find the cycle count;
* an indication of what the normal purging process is and how it might be controlled or prompted to complete while the device is dry and self testing
The device the touchscreen is illuminated and flashing and still flashing when i open device i see a1board flashing when i remove a2 board control panel the a1 board still illuminated not flashing
I am looking for manuals (service and/or user), PM checklist, or information describing differences in operation, service, or parts between the Flex version and the original version.
I have been asked to PM a Cryo 3 Flex. I can see a few differences, but I'm not sure what else there might be, and what I would want to do differently in a PM.
Sakura VIP 6 AI tissue processor. Errors 321 and 324 are not listed in the service manual for the VIP 6 (I haven't seen a service manual for the "AI" version). It appears that these are new codes for the "AI" version of this processor. The description closely matches the description for errors 311 and 314. Does anyone know what the differences might be? Does anyone have a service manual for the VIP 6 AI?
