Laboratory Forums

0 Replies

hi all, How to set up a specific port on XN1000 machine ? We have multiple devices cross country and each one should communicate on a specific port. Instead of 10001 the device shows port 10005. any clue where that can be changed? thank you

Equipment: XN 1000

RE: Sysmex - XN 1000

0 Replies

no disc Install

RE: Mindray - BC-5300

1 Reply

Looking to find a service manual for the Nanosonics Trophon EPR

Equipment: nanosonics trophon epr

RE: Nanosonics - Trophon EPR

1 Reply

I am getting a U20 error at power up, can't find any manuals to use for troubleshooting, anyone ever seen this error? and repaired?

RE: UNICO - PowerSpin HX

0 Replies

COMO RETIRAR ERRO EOFF DA CENTRIFUGA NUVE NF800?

Translation:

HOW TO REMOVE EOFF ERROR FROM NUVE NF800 CENTRIFUGE?

RE: Nuve - NF 800/800R

2 Replies

COMO RETIRAR ERRO EOFF DA CENTRIFUGA NUVE NF800?

Equipment: NUVE NF800

RE: Nuve - NF 800/800R

1 Reply

Service manual 

Equipment: Swelab - Alfa

RE: Swelab - Alfa

1 Reply

why does it keep showing preheat bath temperature sensor error?

Equipment: mindray bc-10 CBC machine

RE: Mindray - BC-10

1 Reply

What size Gas strut does this does the C12 use to hold the lid. and are there any known suppliers?

Equipment: Awel International - C 12

RE: Awel International - C 12

0 Replies

I'm trying to put this back together after replacing a part on the pcb.  Everything went fine until the last connector- a ribbon which plugs into a port on the edge of the board.  It came out easily but doesn't want to go back in.  Is there a trick to it?  I don't want to force it and damage it.

Thank you,

Richard Miller

Equipment: Thermo Fisher Accuspin Micro 17R

RE: Fisher Scientific - Accuspin 1