Our traction table makes a loud knocking noise when a patient is on the machine. I notice the higher the weight we set, the louder the noise. Does anyone know what can be causing this and how to fix it?
"Table needs servicing" message appears during lumbar cycling. I've tracked the problem a bit. It seems like the pneumatic regulator is not getting the signal to open up and let the air pass through from the compressor to the rest of the system. This signal is however seen when using the cervical function because it opens up just fine. I can also see the signal with my multimeter coming from the analog module when in cervical mode.
I was performing a load cell zero and the device popped up with an error 309. The error immediately returns at power up and will not let me access any menu including the calibration menu. The first suggestion in the service manual is to perform a calibration, which I am unable to attempt because I cannot access the menu. Any suggestions? RE: Chattanooga - Triton DTS
I can hear the click when the "Rope Release" button is pushed and the rope may go in 1/2", but then stops. When I go into the "calibrate" screen the real time tension is at zero and increases when I pull on the rope. Thanks for any help!!
