- All Categories
- Laboratory
- Amino Acid Analyzer
- Automation System, Laboratory
- Bilirubinometer
- Biomedical Freezer
- Biotech/Life Science
- Blood Culture Analyzer
- Blood Gas/pH Analyzer
- Blood Grouping System
- Cell Processor
- Centrifuge
- Clinical Chemistry Analyzer
- Coagulation Analyzer
- Cryostat
- Cytometer, Flow
- Electrolyte Analyzers
- Electrolyte Analyzers
- Electrophoresis System
- Embedding Center
- Glycohemoglobin Analyzer
- Hematology Analyzer
- Histology Analyzer
- Histology Printer
- Immunoassay Systems
- Incubator, Laboratory
- Laminar Airflow Hood
- Microbiological System
- Microplate
- Microscopy
- Microtome
- Oximeter, In Vitro, Laboratory
- Photometric Microplate Readers
- Platelet Aggregation Analyzer
- Refractometer
- Refrigerator, Blood Bank
- Slide Stainer/Prep
- Spectrometer, Laboratory
- Spectrophotometer
- Thyroid Uptake System
- Tissue Processor
- Ultrasonic Cleaners
- Urine Analyzers
- Warming Cabinet
- Washer/Decontaminator
Washer/Decontaminator Forums
RE: TROPHON EPR N100010
I am trying to prepare two generation I machines (2012, 2014) for resale and require the cycle count so that the buyer will be able to predict the next PM. I assume the cycles should be info that can be viewed using sequenced keying on bootup, but there are no directions in the user manual and nothing I have tried has worked so far. The boot up initial display shows only S/N and software info. Both machines pass their self texts and proceed into the purge cycle where they continue unless powered down. Both seem to complete an initial stage of purging after about 15 minutes and then shift into something pretty much the same after a couple of seconds of what sounds like electronic switching.
What I would like is:
* directions for the cycle recall sequence or whatever process is required to find the cycle count;
* an indication of what the normal purging process is and how it might be controlled or prompted to complete while the device is dry and self testing
Thanks
Bruce Raynor
Equipment: TROPHON EPR
RE: Nanosonics - Trophon EPRhello, we are having problems adjusting the parameters of one of the machine's programs and in order to do so we need the programming password, we've tried getting help from pretty much everywhere but to no avail. if anyone knows it could you share it? it would be greatly appreciated
thank you!
hello, we are having problems adjusting the parameters of one of the machine's programs and in order to do so we need the programming password, we've tried getting help from pretty much everywhere but to no avail. if anyone knows it could you share it? it would be greatly appreciated
thank you!
Getting erro code 11030 low temp chamber. Phase washing 1. What could be causing that error?
RE: Getinge - 8666Equipment: STERIS - Amsco 5052
RE: STERIS - Amsco 5052Can anyone answer a question about the printout on these units. Staff wants it to display actual elapsed time/actual temp on each printout. Right now it just basically says cycle passed.
Does anyone have information relating to the PPM requirements for the EDT4 please including frequency and parts needed? Thank you.
RE: Olympus - ETD4