Analyzer Measurement & Simulator Forums

i had a Gossen Mavo spot2 usb , i use it for autocalibrate  HFA 8xx by usb , when i use it in instruments with SOwin7 i no had problem ,but if i use it in instruments with win 10 it is not recognise from the instrument and not work. Someone can help me plese

Equipment: Gossen Mavo-spot 2 usb

could you please provide me with the user manual or maintenance guide in pdf format for the impact device used for autologous cell

thank you very much for your support

Equipment: Impact

Looking for instructions to calibrate flow rate please.  Thanks!

Please help me with service manual. I have problem with Power supply and I need more information as check it.

if somebody can help me ...the screen said

Fault detected...

Mains out of range

Equipment: fluke esa 620

Dear MedWrench Community,  Can you please tell me where I can download French User Manual for Multisizer4e

Sincerely Yours, Konstantin

Equipment: BECKMAN COULTER Multisizer4e

Hello, Help, some one that can help me, my Impulse 3000, is getting wrong readdings, can some body help me with the service manual or the calibration procedure? 

Thank you very much for your help. 

Take care.

I would like to construct a cable to connect the BOWA ARC400 to the foot pedal connections on the Datrend vPad-RF Electrosurgical Analyser.  The service manual gives the pinouts but omits the information about the type of connector and also what is connected in the foot pedals for the coding pins.  Any help greatly appreciated.

Equipment: BOWA Electronic ARC 400

I have an Unfors Solo Dent  (B22 1010-A) unit.

I need to change the rechargeable battery. The service manual specifies a 7.4V rechargeable battery but the unit appears to have connectors typical of a 9V battery.

Could I use a li-ion rechargeable 9V battery without damaging the unit, please?

What would the minimum mAh you would recommend?

Thanks  

Equipment: Unfors RaySafe - Solo