Beds/Stretchers/Mattresses Forums
In our Rehabilitation Clinic 2 beds in the same room suddenly stopped working, both the hand control and the nurses control panel.
We have the beds since March 2018 and never had a problem.
Can you please help us with suggestions?
Kind regards,
Petra.
RE: LINET - Image 3Hi! When lowering the bed, there was a table too close which prevented lowering. After moving the table, none of the controls work. I've unplugged and plugged back in but no response to button presses. Is there a reset somewhere or have I fried the motor?
RE: Hillrom - Advanta P1600When trying to lower the bed, it goes into Trendelenberg instead. There is am orange light on next to the bed lower/raise
Equipment: Hillrom - CareAssist ES
RE: Hillrom - CareAssist ESI have a fleet of 1105s and a few other similar Stryker stretchers, when pumping the bed up they have become hard to pump. They will o up just the amount of force required to push down the pedal is increasing. I have lowered the beds and checked fluids and they leak as soon as I pull the plug so I don't see a leak issue (no leaks found n the cylinders) Is it necessary to remove the top to check the cylinders? I know its easier with the top off but I'm a one man shop s top removal is tough.
Fluids levels look good.
No leaks detected on hydraulic.
No binding in the pedal assembly's.
If it was just 1 or 2 units I would replace the cylinders but it seems to be happening to a lot of them so I must be missing something.
Thanks For any assist.
Equipment: Stryker 1105 Stretcher and more
the brakes lock on both ends, but when you step on the side pedals the brakes will not engage and i cannot find and worn or bent parts . what would cause this and what needs replaced or adjusted ?
Equipment: stryker 1115 big wheel glideaway
Equipment: stryker 1115 big wheel glideaway
Where can I buy a SizeWise hand controller membrane?
Equipment: Sizewise - Advantage
RE: Sizewise - AdvantageEquipment: ICC 411
RE: Savion - ICC 411How can I replace the left head side rail? The service manual doesn't have much clear instruction on how to completely replace the side rail.
Thanks
RE: Hillrom - AdvantaDoes anyone know how to correct a error code 0xC100?
Equipment: Hillrom - Centrella Smart + Bed
RE: Hillrom - Centrella Smart + Bed