Bed Forums
Hi! When lowering the bed, there was a table too close which prevented lowering. After moving the table, none of the controls work. I've unplugged and plugged back in but no response to button presses. Is there a reset somewhere or have I fried the motor?
RE: Hillrom - Advanta P1600When trying to lower the bed, it goes into Trendelenberg instead. There is am orange light on next to the bed lower/raise
Equipment: Hillrom - CareAssist ES
RE: Hillrom - CareAssist ESWhere can I buy a SizeWise hand controller membrane?
Equipment: Sizewise - Advantage
RE: Sizewise - AdvantageEquipment: ICC 411
RE: Savion - ICC 411How can I replace the left head side rail? The service manual doesn't have much clear instruction on how to completely replace the side rail.
Thanks
RE: Hillrom - AdvantaDoes anyone know how to correct a error code 0xC100?
Equipment: Hillrom - Centrella Smart + Bed
RE: Hillrom - Centrella Smart + BedI found 5 amp fuse blown on main power board. I replaced and powered it up and a flash and 5 amp fuse is blown again. any suggestions to what is causing this issue? Thanks,
Equipment: Hill-rom care assist 1170G
RE: Hillrom - CareAssist