- All Categories
- Surgical
- Anesthesia Equipment
- Aspirator
- Autotransfusion Unit
- Biopsy
- Blood Warmer
- Corneal Topography System
- Cryosurgical Units
- Diathermy Unit
- Electrosurgical Unit (ESU)
- Endoscopy
- Fluid Management Systems
- Image-Guided Surgery System
- Lesion Generator
- Microscope-Surgical
- Patient Positioners
- Phacoemulsification Unit
- Radiosurgery
- Smoke Evacuation System
- Surgical Head Lights
- Surgical Light
- Surgical Slush Machines
- Surgical Table
- Tourniquets
- Waste Management System
Tourniquets Forums
Add Tourniquets to My Bench97 Results
Updated Dec 27 2023
Updated Feb 2 2023
1 ReplyUnit reads cal fail on both sides. We have already checked batteries, jumper, wire to power supply and fuse.
We cannot get the unit to enter cal mode on startup (holding both + and - buttons on the Second Cuff pressure adjustment while powering on). The unit goes through its self-test while powering on, then displays the failure.
As background, the error message first appeared right after we had begun a calibration on the unit. We have been unable to get the unit to do anything else since. RE: Zimmer - ATS 2000
Updated Dec 15 2022
2 RepliesI have had, on two occasions, the cuff inflate without any input from the user. I called tech support and they claimed this is a known issue. Is there anyone who has seen this happen? I haven't seen an alert yet. RE: Zimmer - ATS 2200
Updated Sep 19 2022
1 ReplyDear All , I have this ZIMMER - ATS 2000
im getting this ERROR CODE AMP FAIL.
I did all the measurements didn't found something weird. Batteries are ok . Any suggestion.
Equipment: Zimmer - ATS 2000
RE: Zimmer - ATS 2000Updated Jul 11 2022
1 ReplyI need the part # for the O-rings on the cuff connectors. Or the specifications so I can order some. RE: Stryker - SmartPump
Updated Jan 24 2022
Updated Jul 30 2021
2 RepliesHi there!
So, I have a trouble with my ATS 750. When I try to use it (plugged) there's no function at all -not the display, neither the pressure- but a little gasp-like sound.
When doing the maintainance test, the second one -Cr14- I have no volts reading.
Have anyone else had a trouble like this, or any guess to get te solution? RE: Zimmer - ATS 750
Updated Jun 17 2021
Updated Apr 12 2021
3 Replies I have a Smart pump that after it has been turned on for a while will still sound like it is trying to calibrate, like during the POST on initial power up. RE: Stryker - SmartPump
Updated Nov 11 2020