Power Forums
This morning the ultrasound tech completed for study without issue. Bed elevated/lowered without issue.
When second patient on table, the bed will not change position in response to selection of any buttons on the control. We hear a beep each time make a selection.
Have unplugged bed for more than one minute. Plugged back in . Still not working.
All cords seen in good working order and securely in place.
The ultrasound table is an "Oakworks general with fowler"
Thoughts/Suggestions?
RE: Oakworks - General w/ FowlerCustomer’s unit stuck in elevated position with no articulation.
I’m thinking could be a bad MCB but need to check all the limit switches first.
Does anyone have a service manual for this exam chair? TY!
Email to: James@TurnerMedicalRepair.com
RE: Midmark - 417Customer has a 630-020. Chair has up/down motion with foot and hand control but no other articulation.
Need advice on probable causes and service manual.
TY! James@TurnerMedicalRepair.com
RE: Midmark - Ritter 630Equipment: Midmark - 75L
RE: Midmark - 75LHave a Ritter 223 where chair will raise and lower but back rest is in lowered position and will not raise. Customer has new hand control. Switched back out to old hand control still nothing. No noticeable noises or anything when hand control activated. Any leads on where to start? Clinic is an hour away and want to be prepared. Thanks guys!
RE: Midmark - Ritter 223Can I clean the mattress with "Healthcare Clorox Bleach Germicidal wipes"?
RE: Durabuilt Medical - PMT 8000 HLTThe remote moves all the parts of the chair except for the foot section. There is power and you can hear it wanting to move but nothing happens. Checked the cords and power to that part of the table. All looks good.
RE: UMF - 5020 Power Procedure TableNO BUTTONS WORK AND MOTOR IS RUNNING (IS NOW IN HIGHEST UP POSITION) UNPLUGGED-
ST CHARLES ILLINOIS
RE: Midmark - 117