Radiography Forums

Equipment: IMS Giotto - IMS M189

Hello,

To start at the beginning ... 1st) Tube/collimator was tough to move up/down to column.  Replaced upper brake to column, brake wires shorted to housing when re-assembling.  Repaired wires, routed wires a different way, re-assembled ... Tube/collimator easy to move up/down.  Charged portable overnight, next day went to verify system working before giving to the techs .... rotor cuts out in 2 seconds & system restarts, tests passed, no errors, CB never trips off.   

2nd) Now AMX-4 + when you rotor from Hand switch, can hear relays click, 2 seconds later the displays go blank and startup test pass, display is ready again.   I can hear the rotor spinning in tube,  tube resistance is good. I verified capacitor values on right side. All fuses are good. Reseated Relays on circuit boards.  I have a replaced 1 board at time to the following .... Display Bd, CPU, Rotor Bd, FIL/Kvp Bd.  No errors appear after startup tests.  Can't do any cals because rotor doesn't last but 2 seconds.    Does anyone have any other idea's? 

Thanks

Jeremiah

Equipment: GE HealthCare - AMX 4 Plus

 Shimadzu mobil röntgen ART EVOLUTION teknik servis kitabina ihtiyacim var. Simdiden tesekkür ederim. 

Equipment: Shimadzu - MobileArt Evolution MX7

Heey

I need help 

 While working the cassette got stucked, it has been placed exactly the same as usual with the orange corner on the right hand side closest to the user, as instructed. The cassette is locked into the processor and I can't remove, but the processor is not reading it. I've tried restarting it but nothing has changed

Equipment: Ecoray - HF-525 Plus

Model 46-270954G1 AMX4 July 1999

When lock release is pressed at collimator handles, vertical nor transvers locks will release. Both locks and switches check good. I do not get the voltage on the lock wires to disengage them. It looks like there is more to the circuit than power, switch, and locks.  Anyone have wiring diagram for this model? or any advice on repair.  Thanks

Equipment: GE HealthCare - AMX 4

estou com erro 40617 , apersenta um barolho estranho no tubo e a imagem no foco grosso sai muito fusca, podem ajudar?

Equipment: siemens, multix select DR

Equipment: Konica Minolta - Regius Model 110

Cual?

Equipment: Amx4