Table Forums
Add Table to My Bench2 Results
Updated Nov 30 2022
1 Reply
I had contacted Chattanooga and was referred to a 3rd party to order a motor control board. I received this and put it in. I zeroed out the load cell. The problem still exists. The unit is not usable in this condition. Does anyone have any recommendations to solve this issue? Thank you in advance.
Equipment: Chattanooga - Triton DTS
Updated Feb 28 2020
2 RepliesI have a customer with this rehab table. The actuator is receiving power but is not moving. I believe I may have to replace the actuator. What is the best approach to replacing this? RE: Hausmann Industries - Powermatic 4380