I am trying to figure out where block 5 is. I pulled circuit boards and tested all temp sensors. Sensors tested good. Lid sensors and resistors tested in spec.. As I have no schematics (not available) I cannot trace any circuits easily to find TEM drivers and other possible suspect components.
Any ideas would be welcome!
Thanks,
Dan RE: Bio-Rad Laboratories, Inc. - C1000 Touch Thermal Cycler
Hi! I have a C1000 with CFX96 here that first had an issue with the power supply (did not want to start if power button were on when power cord got connected) that seems ok after changing some 100uF capacitors with low value. Now i can not get the well temp above 93°C and the unit is saying slow cycling. Any advice about where to look? RE: Bio-Rad Laboratories, Inc. - CFX96 Deep Well
Hello I have a problem with the data run. The image sees blurry
I would know if anybody can tell me why it happens that.
Does anybody have the service manual?
Thanks RE: Bio-Rad Laboratories, Inc. - Bio-Rad PTC-100
Dear Team
I face error Number: 000E0019(Protocol run failed to start. Reboot instrument and retry. If error persists, contact Bio-Rad Technical Support). Model: CFX96 Optics Module
Anyone can help me about this error.
Thanks.
Best Regard
DARA
rotha.dara009@gmail.comRE: Bio-Rad Laboratories, Inc. - CFX96 Deep Well
I have a C1000 which won't power up. I found F3, a 5x20mm 5A fast fuse, blown. After replacing it, F103, a 5x20mm 500mA fast fuse hidden under the power inlet, blew when I applied power, but before I turned on the power switch.
RE: Bio-Rad Laboratories, Inc. - C1000 Touch Thermal Cycler
