Hi dear forum. I am seeking help in resolving a problem with a Hologic Lorad Selenia. Can help me with this error ? "Error during worklist query" ,how to solve this problem? I hope that someone can give me support for solving this problem. Thanks in advance. Regards.
Hi friends
I am a biomedical engineer here in Mexico, and i got this equipment. The problem is that when my technicians want to use the auto-modes, sometimes they got this error: "Calculated Exposure time exceed back up time" . I dont know it has to do something with a bad technique.
Also the images when that happens, the breast is totally white.
Manually i do not have that problem. RE: Hologic - Lorad M-IV Series
I am having a situation with the mammography system and it is not having movement in the C-ARM area. It has no upward or downward movement. Neither does the C-Arm rotate. They know what may be causing this or what is most common in these cases. RE: Hologic - Lorad M-IV Series
Hello, dear group.
I am looking for help to find the capacitance value of capacitor that is parallel connected to SSR1 and to resistor R5 at power input of a mammography system LORAD M-IV.
Any help will be highly appreciated.
RE: Hologic - Lorad M-IV Series
Hello everyone. Please help me . I have problems with logging in. Who has the service user name and passwords for a Hologic lorad, Can anyone share me?
Thanks a lot!!!
RE: Hologic - Lorad M-IV Series
Hello, I ask for your help with a Lorad m-iv, the equipment turns on and arrives at its startup screen, then when it goes to the screen to admit patients, the equipment re-initializes and remains in this indefinite cycle ... I assume it was corrupted the software...
I would be very grateful if you can help me with this case ... I don't have the equipment software
Thanks RE: Hologic - Lorad M-IV Series
Hello, dear group.
I need your help, please.
When trying to make an x-ray exposure, error 23 or 27 appears, randomly error 35 too. Any kv, any mAs, both filaments.
Filament cal done. Standby current cal done ( voltage across R74 is 0.250 Vdc). Led D15 at HV control board lights on when error occurs. Same condition with led D2 at filament control board. What could be the cause? Any help will be highly appreciated.
Regards. RE: Hologic - Lorad M-IV Series
Hello dear group.
I am looking for help to solve a problem in a mammography system.
In the starting up process, the screen control shows:
"162 - System options not configured (Execute SETUP in
REFERENCE DISK)
(Resume = "F1" key)
Press to run setup "
After that it shows:
"No disk in system or disk error
Replace and press any key when ready "
Any idea what it means?
The service manual does not cover this topic. Any help will be greatly appreciated.
Thanks in advance.
Greetings. RE: Hologic - Lorad M-IV Series
