Hello,
I am looking for Shimadzu P324DK tube replacement(alternative type). Do you know what tube can replace this one, even without tube housing(only to reload the tube) ?
Thank you in advance RE: Shimadzu - FLEXAVISION F3
Hi family MedWrench.
I have a fault with the Shimadzu Flexavision, there is no anode rotation and no x-ray emission. Let me explain everything I've done:
The initial fault of the equipment was that it did not show the values KV, mAs, etc., of the generator and configuration on the console displays, the only thing that worked was the movements of the table. Cheking the equipment I discover that the UDCONT Led data reception does not turn on or blink, thats mean there is no communication. Replacing the board everything in the console works normally and in effect the Leds of data transmission and reception works. Now the problem is that there is no anode rotation and no x-ray emission, in console does not indicate any error.
By pressing preparation, acquisition or fluoro pedal, you can see the status LEDs on the UDCONT, additionally I place the jumpers and micro switches in the position of the original board just like it.
I do not have the service manuals of this equipment and neither experience in this model, I would appreciate the help of you and also the possibility of sharing these manuals ..
I wonder if this is some failure due to lack of firmware loading or version problems that I do not know, I think this because the equipment fault and the system does not throw any errors.
Finally, I indicate the versions, the original UDCONT 2005 board, the software version is not specified, its part numbers are 502-25066-B and 502-25067-B, the new board, the software version is 2.90 and its part numbers is 502-25066-F and 502-25067-C.
Many thanks in advance for your cooperation. You can contact me by the email alfredobm39@gmail.comRE: Shimadzu - FLEXAVISION F3
