Thermo Fisher Scientific - CryoStar NX70
Thermo Fisher Scientific CryoStar NX70 Forums
Add Cryostat to My Bench5 Results
Updated Aug 19 2021
1 ReplyON one my NX70 the chuck temp is not maintained and keep higher over time. RE: Thermo Fisher Scientific - CryoStar NX70
Updated Dec 9 2019
2 RepliesI looked through the documents to figure out how to flush the brine pump system. However, while I understand the process, I can neither find the brine pump itself nor the outputs menu to check on the status of the brine pump. Any assistance would be appreciated, as I do not have a service manual. RE: Thermo Fisher Scientific - CryoStar NX70
Updated Oct 27 2019
Updated Oct 10 2019
3 RepliesDoes anyone have a Service Manual for a Cryostar NX70? Specifically, I need to flush the brine system and I may need to replace the brine pump. RE: Thermo Fisher Scientific - CryoStar NX70
Added Feb 22 2019
0 RepliesThermo CryoStar NX70 cryostat, with adjustable height. Histotech was raising the height, without paying attention. It apparently raised to the maximum, and will not go back down again. Has anyone run into this? If so, did you have to replace the main pcb, or did you find some other cause/solution?
Note: the CryoStar NX70 and NX50 are not listed under "CryoStats," so I am asking in the general forum. RE: Thermo Fisher Scientific - CryoStar NX70