GE HealthCare LOGIQ P5 Forums

1 Reply

Showing not connected on lcd while the dp 33 light is also off in supply 

Equipment: Ge logic p5 ultrasound machine

RE: GE HealthCare - LOGIQ P5

1 Reply

 J'ai besoin d'aide mon logiq p5 ne démarre pas et affiche un message : root noverify (hd0,1)
chainloader +1
makeactive 

I need help my logiq p5 does not start and displays a message: root noverify (hd0,1) chain loader +1 makeactive

RE: GE HealthCare - LOGIQ P5

0 Replies

This p5 has a random dropout at any given time random spots with all probes, I am unable to recreate and only seen pics of the issue by the techs.  Thoughts?

RE: GE HealthCare - LOGIQ P5

5 Replies

i have a GE Healthcare - LOGIQ p5. ultrasound machine that has a boot and shutoff problems intermediately also, I don't have its software to relodge it. again i would like. someone gives me a clue. that helped me to fix this problem. anub

Equipment: GE Healthcare - LOGIQ P5

RE: GE HealthCare - LOGIQ P5

2 Replies

Hello everyone. Our machine got an issue. Once it started "no boot" message appears. When I entered to BIOS to check hard disk is "not detected". I pull out hard disk, using another computer to check if it runs. Yes. It's is run on another computer. Voltage from aps to HDD cable is also 12v, 5v. Is anyone got issue like this?

RE: GE HealthCare - LOGIQ P5

7 Replies

Unable to restart the machine with the a Disc read error occurred. How do I solve this . The machine is GE Ultrasound P5

RE: GE HealthCare - LOGIQ P5

3 Replies

the system will not load past the loading screen. i tried the reboot as well as redownloading software. i also swapped HDD. i swapped SYSCON board. Nothing is working. It powers on and loads but then stays on the LOGIQ loading screen after loading bar goes away. How to fix this?

RE: GE HealthCare - LOGIQ P5

0 Replies

I have a Logiq P5 that is freezing on the loading screen. I've done a software reload and application reload. SYSCON and APS board was swapped and unsuccessful. The bios update is disabled. Any suggestions?

RE: GE HealthCare - LOGIQ P5

0 Replies

My machine starting hang up soon after start i mean logo lpading or sometime after entering into exam. So i check all possibel scineriao even change with new software, at end i take out cpu board and recheck it. But reinstalling it, its not entering into software black screen and saying not connected.... Can u guide is it cpu boad issue or somethung else. If cpu board how much it cost

RE: GE HealthCare - LOGIQ P5

2 Replies

i have GE logic p5 ultrasound, after installing software when i want to print an image, this message occurs (a patient must be selected for a permanent storage images) and it isn't printing, what's the problem?

RE: GE HealthCare - LOGIQ P5