The films are not completely dry when they come out,. ... and have some scratches on them....comsistent with debris stuck to the rollers but machine was cleaned thoroughly so not sure where this coming from.
How do you adjust the Developer and Fixer temp settings from the factory set default of 34 degrees C. I need to set these temps to 30 degrees C to process some film with the correct density.
Bottles seem to be emptying way too fast. Seems to be going straight out the drain tube. Have replaced all 3 tank caps. No change? Why would it be using so much dveloper, fixer, and water? Just started doing this after tech removed trays for cleaning.
AGFA CP 1000 film processor. Fluid level in all tray(tanks) too low. Replaced all 3 valves on replenisher bottles, no difference. Two different techs came out to fix, but couldn't. Tanks will fill when "manual replenishment" switch is activated - but this shouldn't be necessary. Any ideas??? Jerry
