Philips - Brilliance 16
Philips Brilliance 16 Forums
Add CT Scanner to My Bench18 Results
Updated Jun 11 2023
1 Reply
When I am trying to switch on the gantry the gantry is not booting and when looking in error log it shows S MASTER SEQUENCER ESTOP IS NOT CLOSED. What need to do??
Equipment: Philips - Brilliance 16
RE: Philips - Brilliance 16Updated Apr 10 2022
3 RepliesThe CT table will only go up and down by about half inch increments with each push of the buttons. Any suggestions? RE: Philips - Brilliance 16
Updated Mar 29 2021
1 ReplyDear Technical team ,
Gantry key goes off after few seconds of starting and sometimes rotation starts and x-ray works with only 90KV and 100MA.
Finally Gantry key doesn't come on and we found the 3 fuses 20A blown from cathode power module side. RE: Philips - Brilliance 16
Updated Feb 12 2021
1 ReplyHi, In the way i need to move the scanner there is a door with 203 cm height, other doors max.210 cms. I am planning to remove the covers and the upper part of the gantry. Anyone has this experience? I need some factory recommendation but i do not see in the manuals. Pls, help. RE: Philips - Brilliance 16
Updated Jan 15 2021
6 RepliesHello, we have installeed Philips brilliance 16 ct air cooled from good and working condition.We conect everything follows installation manual but we have problem.When turn on TEAL main power everything works fine but we cant power on gantry on key.
ESTOP CONTACTS ARE OPEN and ESTOP CURRENT IS NOT FLOWING is yellow on board.
On the host we dont have estop button warning and all buttons are open.
Common erorr is NTCAN_INVALID_HANDLE
Thanks RE: Philips - Brilliance 16
Updated Aug 24 2020
5 RepliesHello,
The gantry is shutting off a few seconds after key is turned on upon bootup. Sounds like a contactor turns off. Any ideas? Going to take a first in the morning. RE: Philips - Brilliance 16
Updated Jun 30 2020
Updated Dec 16 2019
2 Replieshave problem with ct Phillips brilliance 16 slice: when I trying turn on the sytem from the key its not start. Gantry is rotate but its not parking and leds on the gantry not turn on.
When i turn on the key i see Errors in viewer:
s_rmc__error_mco
S rms sb fault
S rms mp dth bad param
S rmc dth bad param
S rotor dth bad param
s collision bad dth param
May be its spindle block fault?
Can you help me? RE: Philips - Brilliance 16
Updated Jan 19 2019
7 RepliesDear Members , i am facing a problem seems a safety interlocks and the error seen on Dase screen which is `SERDES LFI ` and the side main control board shown` Estop Contacts are open` and `Estop current is not flowing` their LEDs colors are in yellow in observation in Philips Briliance Mx 16 CT Scan. moreover the frent panal screen does not goes to 0000 and then disappear the screen lights and shown the above error. thats why i am not be able to proceed the key switch to turned up.
while all the safety loop are working fine .
could some one help me to fixed this problem? RE: Philips - Brilliance 16
Updated Oct 10 2017
3 RepliesHello i have problem with Recon from IRS
I have change the ethernet cable but nothing, problem is in F: HDD RAW DATA help me how to replace the HDD RAW DATA RE: Philips - Brilliance 16