EPPENDORF - Centrifuge 5417 R
EPPENDORF Centrifuge 5417 R Forums
Have problem two front of top side of housing screws. I removed two phillips screws on front part of housing but I am not able to put it back. Is there any special tricks? Seems like screws are little small but I am sure that screws are from that side.RE: EPPENDORF - Centrifuge 5417 R
Centrifuge 5417R with s/n>7000.
When I turn the power switch on, the relay REL602 clicks, the 'open' and 'soft' LED indicators on the front panel flash green and .. nothing more. The CFuge is dead.
Please tell me how to fix this problem. Thank you = TimRE: EPPENDORF - Centrifuge 5417 R
I need to replace the main power switch on the right side of the unit. How is access best obtained for this? Remove the upper housing? Or the front panel?RE: EPPENDORF - Centrifuge 5417 R
I removed the two screws at the bottom front and was able to pop the cover pin catches near the top on each side. I detached the ground cable on the right side. However, there is a long white "string" (looks like woven fabric) that is wrapped across the front of the circuit board (top to bottom) and goes through a platic loop inside the front cover -- this seems to be holding the front cover on. Does anyone know where/how to detach this "string" on one end so I can finish getting the front cover off?RE: EPPENDORF - Centrifuge 5417 R
have a error 20 on a 5417r eppendorf . looking for service manual or someRE: EPPENDORF - Centrifuge 5417 R
this unit is able to complete the runs with no error message the fan is stuck and the compressor does not turn on, compressor winding reads 5.2ohm, 2.0 ohm, 6.7ohm and no short to chasis. It seems like there is no ac voltage coming to the bottom prong (this wire is coming from the front pannel. Please help.
RE: EPPENDORF - Centrifuge 5417 R