EPPENDORF Centrifuge 5810 / 5810 R Forums

4 Replies

Hi,

     Where can I purchase repair parts for Eppendorf centrifuges? Specifically 5810 5403

Thanks

Tim

Equipment: Eppendorf

RE: EPPENDORF - Centrifuge 5810 / 5810 R

10 Replies

I was asked to look at an Eppendorf 5810r - 5811 (120VAC-15A model) with an Error 22 code.

The unit powers up but goes immediately to a Error 22 - Switch off message.

Could someone provide some direction for me to investigate, diagnose and hopefully repair this?

Thanks,

RE: EPPENDORF - Centrifuge 5810 / 5810 R

2 Replies

I need to replace a condesor fan and it's K5 relay. I cannot find any information or part number for the relay. The fan might be part# 022669788 but I am not sure because that is for the newer model. If anyone has a parts list for the refrigeration group, or preferably a substitute part, that would be much appreciated. I was hopng to order before spending hours tearing down the machine to access the parts.

RE: EPPENDORF - Centrifuge 5810 / 5810 R

1 Reply

Where can I get a Service Manuel for a eppendorf 5810R

RE: EPPENDORF - Centrifuge 5810 / 5810 R

1 Reply

What is this code and what needs to be done to clear it

RE: EPPENDORF - Centrifuge 5810 / 5810 R

4 Replies

What is this code and what needs to be done to clear it

RE: EPPENDORF - Centrifuge 5810 / 5810 R

4 Replies

When I close the lid, the unit shuts off then powers back on by itself. It's a 5810R. Does anybody have any idea what could be causing this. Thanks in advance. Rick

RE: EPPENDORF - Centrifuge 5810 / 5810 R

9 Replies

Hello, have some issue with error code 31. when it started it door latch is hunting and ends up with error code 31. I replaced two sensors on the door latch but did not help. changed PCB board with brand new same thing happens. Anyone have any ideas?

RE: EPPENDORF - Centrifuge 5810 / 5810 R

3 Replies

Anyone able to supply a service manual for a 5810R or the method of changing the lid strut. Thankyou in advance

RE: EPPENDORF - Centrifuge 5810 / 5810 R

2 Replies

Hi to all, i need replace the main board of this device and from Eppendorf says this procedure can do it only the oficial service because when you replace this PCB is necesary adjust the imbalance sensor. If in this case the information it's true: How can i do that procedure? Is posible to explain me? Thanks in advance...

RE: EPPENDORF - Centrifuge 5810 / 5810 R