I also am looking for the service manual or calibration instructions for Eagle 10. Could someone please help me with this or point me to the right direction ? My e-mail address is: bopast2190@yahoo.com
Thanks RE: STERIS - AMSCO Eagle 10
1. We tried to run the 5.2.3 Verifying Heater, Relay, and Valve Functions program however could not get the desired F7 to appear.
2. I ran 3 Unwrapped cycles which produced error codes E03, E97 and E14
3. The final run yesterday aborted at 91C at ~ 17 minutes, no detectable pressure though I know the gauge works as I tested it off the autoclave.
In view of the age of this unit [and possibly scarcity of parts] would you recommend us investing time & resources to attempt repairs? RE: STERIS - AMSCO Eagle 10
Does anyone know why the power to the heater element would stay on even after replacing the SSR ? The dc voltage input to the ssr is always on even when no cycle is running. I also checked the heater element for short to chamber...none found. I suspect the optocoupler on the control board to be bad.... Does anyone know which one that may be? Does any one have the service manual to the Eagle 10 they would be willing to share? My email is: leon@lab-care.com? Thank you guys! RE: STERIS - AMSCO Eagle 10
Hi I noticed some of you had a copy of the Eagle 10 Autoclave service manual. Would someone be so kind as to send me a copy to Heritagemed@gmail.com please. I greatly appreciate it. Hal @ Heritage Medical Thank you very much :)
Hi I noticed some of you had a copy of the Eagle 10 Autoclave service manual. Would someone be so kind as to send me a copy to 3dscopes@gmail.com please. I greatly appreciate it. Bruce 3D Medical :)
