When I turn on the console it will boot up to the main screen, but I can't pick techniques, or select from the APR. All the squares that should have numbers or options inside of them are missing, all I see are empty boxes and no errors. I removed the cover of the generator and noticed that the IF board had no LED lights on, I only see 2 led lights on the COLL IF PCB and it is not the TX or RX LED. I measured voltages on the test-points and Im getting +12vdc , -12vdc, +5vdc and +9vdc. Could my collimator be the cause of the problem, or should I replace the Collimator IF board and PCB assembly in the generator? I noticed a day prior, seeing the main display on the collimator blinking on and off rapidly , but now is off. Should I focus on the collator instead? Thank you!!, Keith RE: GE HealthCare - Proteus XR/a
Technique and Parameters do not display at startup / remote doesn't work. I have disconnected all cables and reconnected. It will power on, but not display any numbers. RE: GE HealthCare - Proteus XR/a
Hello, My Proteus XR/a System Console touch screen start to crack and less responsive. I wonder if anyone have experience of changing the touch panel before? What is the touch panel part number? and where i can purchase it?
Thanks in advance. RE: GE HealthCare - Proteus XR/a
When turning on my Proteus XR/a I get a message "Please Power Up Again" about 30 seconds after powering on. This unit does have a DR Upgrade. This is intermittent and sometimes you just need to reboot it a few times. Any ideas of what to look at? I am thinking the KV board. There are not any error codes logged.
I have a GE Proteus system with the WDR1 Wireless DR Imaging option. It intermittently looses connection with the DR panel. I went in and the Signal Strength is Excellent (31), Link Quality is Excellent (8), and Bandwidth is Excellent (52). In the Error Log I see some Error Code 1221093 Digital Detector Communication Lost, Error 1201210 Timeout occurred, and 1201207 Link quality is low errors. Mostly the communication lost errors. This seems to be very intermittent, will not connect when removed from the charging bin or they loose connection between exposures. Anyone have any experience with similar problems.
Intermittently, when the exposure switch is pressed (even after being fully prepped), the console exhibits error 60, 803 which means the generator was asked to expose before it's ready. Someone suggested that it may be related to a faulty fan in the console. The svc manual indicates that it could be caused by software, communication/cabling issues, or power spikes. Has anyone seen this before?
I am having an exposure issue with no errors only on to the wall bucky. It will rotate and the bucky recipracates but no exposure. But on the next try I will get an exposure. Also some days it works fine with no issues and others it will happen several times in a day. I have replaced the hand switch and the receptical in the wall bucky. Im ordering the circuit board and the motor for the bucky. Any suggestions? Am I on the right path?
