I am trying to prepare two generation I machines (2012, 2014) for resale and require the cycle count so that the buyer will be able to predict the next PM. I assume the cycles should be info that can be viewed using sequenced keying on bootup, but there are no directions in the user manual and nothing I have tried has worked so far. The boot up initial display shows only S/N and software info. Both machines pass their self texts and proceed into the purge cycle where they continue unless powered down. Both seem to complete an initial stage of purging after about 15 minutes and then shift into something pretty much the same after a couple of seconds of what sounds like electronic switching.
What I would like is:
* directions for the cycle recall sequence or whatever process is required to find the cycle count;
* an indication of what the normal purging process is and how it might be controlled or prompted to complete while the device is dry and self testing
The device was recently calibrated but it needs to be moved to a new location. Will it need to be re-calibrated or are there other steps to follow? RE: Nanosonics - Trophon EPR
What is the process for cleaning the Trophon 2 unit itself? I read mild soapy water , but also read disinfecting wipes. How often do you use the mild soapy water and how often do you disinfect the outside and inside of the unit? Also, how do you open the unit once you have turned if off and it has cool down? RE: Nanosonics - Trophon EPR
Showing an error message with error code DVF 0008, went thru all troubleshooting message. it continues with system failure. Do we need to send out for maintenance. RE: Nanosonics - Trophon EPR
I turn on the equipment and the warm up process begins. before it completes the process I get an error message of DGW8028 can someone tell me what this error means? RE: Nanosonics - Trophon EPR
