I'm looking for a service manual for a Siemens Ysio system in digital form. I'm specifically looking for a theory of operation for the alignment of the tube to the table FD. I have a symptom that the machine won't come to ready when pointed at the table bucky but will show ready status if the tube is rotated horizontally roughly 20 degrees. Has anyone else experienced something like this?
Thank you in advance for your help. RE: Siemens - Ysio
I need a service manual for the Siemens Ysio (especially for the 3D Top overhead crane). I only have On-site Siemens docs, and that is the installation and operation manual. I have a dropbox account. Thank you, Tim
RE: Siemens - Ysio
I have a Ysio rad room with error code "20551 Flash 80". The room has been rebooted to no avail. Can this problem be resolved by the operator rather than calling in OEM service? RE: Siemens - Ysio
What is the optimum EXI value in Siemens DR Ysio? If the values is in range, what is the range? Could you provide jurnals or valid literatures to support the exposure index values stated? RE: Siemens - Ysio
On the Siemens Ysio/Ysio Max, does the wi-D detector charge in both the table and wall bucky? I have seen some documents that say both and other documents just say table and doesn't mention the wall bucky.
error message : measured dose is below to limit refer to UM.
actions has been done , checked RAD and configs, cheked collimater, tube is checked , i did free exposure also , always the exposure comes long or wide its not cutted !
any suggestions , i suspect there is board in generator or part of it defective
