I was repairing 06 ventilators ( Blease spacelab 700 series), 05 repaired successfully, last one ventilator does not sense oxygen, replaces oxygen sensor, Oxygen Board (PCB) but still does not sense oxygen, if Oxygen sensor removed it given Err Oxygen.. when connected Oxygen sensor it shows 0.0 with Oxygen low error...looking for service manual or a good advise from experts. RE: Spacelabs - BLEASE 700 Series
Blease spaceblabs 700 Ventilator oxygen low, error, checked and replaced new oxygen sensor with old one, still error low oxygen, replaced sensor cable, then replaced PCB board where oxygen sensor cable is connect, at back of ventilator, still same error,, oxygen showing 0.0 and error say OXYGEN Low ...looking some expert tips to solve this problem (when cable is disconnected from oxygen sensor then on display show Oxygen "Err." if cable is connected it displays 0.0 and at top shows oxygen Low) ..if some one help plz RE: Spacelabs - BLEASE 700 Series
urgent needed service manual ,,Blease spacelabs 700 ventilator , when ventilator switch on, and after all test bypass, at home when we try to set any value of vol, pressure, i.e ratio or any other ,,,,cursor start jumping , auto different values are adjusted,,overall system goes out of control..looking if some one can help to over come this issue RE: Spacelabs - BLEASE 700 Series
Hi i'm an anesthetist. user of blease anesthesia machine 700 series and i'm having issues regarding use of this machine and differenet flow sensers issues. i dont have the user manual of this machine so i'm here to request one. Please provide me with user manual so i can accomply this problem as soon as possible.
Thank You RE: Spacelabs - BLEASE 700 Series
The device does not turn on, led indicator close to the selector wheel is flashing.
The AC/DC module delivers 24 VDC but only without being connected to the next module. If i connect the ac/dc converter module the problem shows again. I Think its the module that sends diferent voltages to the controler card, display card, etc.
Hi, i am kakha makharadze medical equipments engineer at batumi medical center (Georgia, medical corporation "EVEX"). We are running equipment "blease 700/900" on adult mode, need to change on pediatric mode. In this process requires service password, please send us password end service manual on this contact email. In our country there is not service for this equipment.
Hi, i am kakha makharadze medical equipments engineer at batumi medical center (Georgia, medical corporation "EVEX"). We are running equipment "blease 700/900" on adult mode, need to change on pediatric mode. In this process requires service password, please send us password end service manual on this contact email. In our country there is not service for this equipment.
I have a blease ventilator 750 which is not delivering required (set up) Tidal Volume.That is when the Tidal volume is set at 900ml, it can only deliver up to 500ml.
