Forums

Hi everyone,

Can you send me service manual of Maquet-HCU 40.

Thank you.

Hello, dear group.
I´m servicing to a C-Arm Pulsera from Philips. When making fluorospopy get blurred images. I´ve already checked voltages on image intensifier power supply. Voltage measured at test point Vg2 is +3.15v, it does not change eventhoug I change format to 17 cm or 23 cm. But according to technical specification on service manual, it should be +0.8v. Those grid voltage values make me think that II power supply is damaged, but I´m not sure about that. Could anybody help me to make a better diagnostic? Your assistance will be unvaluable.
Thanks before hand.
Regards

Equipment: Philips Pulsera C-Arm

Hello, dear group.
I´m servicing to a C-Arm Pulsera from Philips. When making fluorospopy get blurred images. I´ve already checked voltages on image intensifier power supply. Voltage measured at test point Vg2 is +3.15v, it does not change eventhoug I change format to 17 cm or 23 cm. According to technical specification on service manual, it should be +0.8v. Those grid voltage values make me think that II power supply is damaged, but I´m not sure about that. Could anybody help me to make a better diagnostic? Your assistance will be unvaluable.
Thanks before hand.
Regards

Equipment: Philips Pulsera C-Arma

Equipment: ZEISS - i.Profiler

Service manual

Equipment: Toshiba - Xario XG

I need the preventive maintenance procedure pdf for the biograph 16 non true point system. Thanks

Equipment: Siemens - Biograph 16

Equipment: Biograph 16

I need a service manual to know how to run a optical calibration using a calibration strip

Equipment: ARKRAY USA - SPOTCHEM D-Concept

Hello, dear group.

I´m servicing to a C-Arm Pulsera from Philips. When making fluorospopy get blurred images. I´ve  already checked voltages on image intensifier power supply. Voltage measured at test point Vg2 is +3.15v, but according to technical specification on service manual, it should be +0.8v. Those grid voltage values make me think that II power supply is damaged, but I´m not sure about that. Could anybody help me to make a better diagnostic? Your assistance will be unvaluable.

Thanks before hand.

Regards

Equipment: Philips Pulsera C-Arm