Forums

The device works perfectly. I have a fault at start up: HCU Supply. 00110006.

What can be the cause of this fault and how can I repair.

Equipment: MAQUET - HCU 40

Hello!

We need to replace the battery of our ventilator Penlon AV-S2, but I cannot find the instructions in the service manual.

Does anyone have access to the procedure?

Equipment: B. Braun - Perfusor Space

Just an FYI: if you have no power, look for the two fuses above the in line power filter. If they are blown, it could be the reason your unit isn't powering on. A co-worker and I discovered that one was blown and we replaced them and now the unit works. Sometimes it's the simplest things.

An oil change was performed because initially errors 26 and 29 appeared, which mention something about the generator overheating or a malfunction. Upon inspection, an oil leak was found, which was the likely cause of the overheating. After changing the oil and gaskets, the generator started again, but now error 28 is appearing. The technical manual available online provides absolutely no information about this error. Has anyone else experienced this?

Hi everybody

 did know someone how to reset the air filter hours counter ? this device has on panel buttoms for temperature , flow and ON/OFF. may be a combination of them but I don´t know

Equipment: CCalima 22 by Celsius Medical for Medtronic

After doing the XRC calibration successfully i try doing the image cal and it states that it lost communication with the camera has this happened to anyone else?

Hello, I would like to know if software for Ventana BenchMark ULTRA can be purchased

Thank you

Equipment: Ventana BenchMark ULTRA

Alguien sabe cuales son los tornillos que debo apretar para que la mesa no este suelta? los frenos están puestos, y ya aprete absolutamente todos los tornillos que supongo que pueden intervenir, el movimiento es longitudinal (como si quisieras hacer trendelenburg)

Equipment: oximax 600