Forums

When trying to lower the bed, it goes into Trendelenberg instead. There is am orange light on next to the bed lower/raise

Equipment: Hillrom - CareAssist ES

anyone found a sollution for fixing Display issues whit the Velch Allyn ProBP 2000 Electric Conductive Zebra LCD Display Silicone Rubber Connector

Equipment: Pro BP 2000

Equipment: Philips - IntelliVue MP5

Hello,

HFA 740i
Boots with the message below

System startup state 19
Aperture may be misaligned
(Pressing Proceed will NOT allow testing)

[Retry]                      [Proceed]

Even after pressing [Retry], it persists. Same as when I restart the machine.

Why this message?
What can I do about it?

Please help out.

Thank you.

Hello, I have a case where randomly the error logging records the following events:

 W VSI  Error 40 (IDS Link status not Ok)

Warning IDS Link: # total bit errors detected the ethernet cable  ( value of "#" varies on each logging event) 

I have already checked the ethernet cable but seems ok and I cannot reproduce the failure. Could the DFI-3 cause this kind of problem?  any suggestion? Thx in advance

Does anyone know what the BIOS password is for this Siemens Fujitsu computer?

Equipment: Siemens Fujitsu computer

how to fix corrupted files when sending to PACS 

Good morning, I have this case, xario 200, copy menu does not show DICOM in the SERVER option, only DVD, USB, DICOM does not appear on the server.

How to enable in copy

Equipment: Toshiba - Xario 200

HELLO, I JUST RECENTLY PULLED THE LASER OUT TO USE AND I WAS WONDERING IF ANYONE KNEW WHAT # WATTS YOU SET IT ON FOR THAT INITIAL TEST THAT YOU RUN BEFORE USING IT..?? I HAVE FORGOTTEN.. THANKS FOR YOUR TIME - BRETT

This morning the ultrasound tech completed for study without issue. Bed elevated/lowered without issue.

When second patient on table, the bed will not change position in response to selection of any buttons on the control. We hear a beep each time make a selection. 

Have unplugged bed for more than one minute. Plugged back in . Still not working. 

All cords seen in good working order and securely in place. 

The ultrasound table is an "Oakworks general with fowler"

Thoughts/Suggestions?