Forums
Could anyone provide the service password for the Power Led 300 Storz?
Equipment: ower Led 300 Storz
after powering up the machine gives an error, vent inop 1014 .
I looked in manual and it says it could be caused by one of many faulty PCBs.
have anyone encountered this issue before? and how did you fix it?
thanks
RE: Philips - Respironics V200I have an Unfors Solo Dent (B22 1010-A) unit.
I need to change the rechargeable battery. The service manual specifies a 7.4V rechargeable battery but the unit appears to have connectors typical of a 9V battery.
Could I use a li-ion rechargeable 9V battery without damaging the unit, please?
What would the minimum mAh you would recommend?
Thanks
Equipment: Unfors RaySafe - Solo
RE: Unfors RaySafe - SoloEquipment: GE OEC7700
RE: GE HealthCare - OEC 7700 CompactDear Sir,
I got your email from medwrench.com .
i have a problem with the device in the power on the batteries were dead i connect a generator instead of the battery , it powered on but it doesn't complete and sent a message that it will shut down and discharge the batteries .
Also the AC indicator does not lights when the power cable connected.
i hope you can help
thanks in advance
Regards
Mkrtich Mkhsiyan
Dialog4 LLC, Aztutyan lane 4/44
Yerevan 00054
Armenia
+374 77 980098
Equipment: Esaote Mylab30
RE: Esaote - My Lab 30 GoldLet me ask you a question.
There are two "SIEMens ARCADIS Orbic-arm", and the computer "a" (Celsius M720) fails, replicates the hdd of the other device "b" (Celsius M720), and boots the "a" computer.
It says that the service key is different at the start of the "a" computer syngo program, will it work normally if I get a service ski using the existing "flexid" in "a"?
Thank you.
Fluro is working good,but during radiography (mAs) value decreasing automatically and exposure also not happened.Not showing any error.What could be the problem)?
Equipment: Axiom iconos R200
RE: Siemens - AXIOM Iconos R200Hi! When lowering the bed, there was a table too close which prevented lowering. After moving the table, none of the controls work. I've unplugged and plugged back in but no response to button presses. Is there a reset somewhere or have I fried the motor?
RE: Hillrom - Advanta P1600This unit ( Siemens Sonoline G40) boots up but then comes up with error message "Imaging Initialization failed. System shutting down." Would anyone have an idea as to how to track the problem down or fix the problem???? Thanks for your help
RE: Siemens - Sonoline G40