Nanosonics - Trophon EPR
by Nanosonics

Nanosonics Trophon EPR Forums

Updated  Mar 26 2024
1 Reply

RE: TROPHON EPR N100010

I am trying to prepare two generation I machines (2012, 2014) for resale and require the cycle count so that the buyer will be able to predict the next PM.  I assume the cycles should be info that can be viewed using sequenced keying on bootup, but there are no directions in the user manual and nothing I have tried has worked so far.  The boot up initial display shows only S/N and software info.   Both machines pass their self texts and proceed into the purge cycle where they continue unless powered down.  Both seem to complete an initial stage of purging after about 15 minutes and then shift into something pretty much the same after a couple of seconds of what sounds like electronic switching.

What I would like is:

* directions for the cycle recall sequence or whatever process is required to find the cycle count;

* an indication of what the normal purging process is and how it might be controlled or prompted to complete while the device is dry and self testing


Thanks

Bruce Raynor


Equipment: TROPHON EPR

RE: Nanosonics - Trophon EPR
Updated  Jul 18 2022
2 Replies

The device was recently calibrated but it needs to be moved to a new location. Will it need to be re-calibrated or are there other steps to follow?

RE: Nanosonics - Trophon EPR
Updated  Sep 8 2021
1 Reply

How to PM a trophon EPR

RE: Nanosonics - Trophon EPR
Updated  Jun 21 2021
2 Replies

Anyone have a description of error dgw8000?

RE: Nanosonics - Trophon EPR
0 Replies

What is the process for cleaning the Trophon 2 unit itself? I read mild soapy water , but also read disinfecting wipes. How often do you use the mild soapy water and how often do you disinfect the outside and inside of the unit? Also, how do you open the unit once you have turned if off and it has cool down?

RE: Nanosonics - Trophon EPR
Added  Jun 24 2020
0 Replies

Error code DGW8020, anybody knows what that means?

RE: Nanosonics - Trophon EPR
Updated  Mar 18 2020
1 Reply

Hi

Please if any one can help with this Error code

Error code BF03 and keeps purging NON STOP

RE: Nanosonics - Trophon EPR
Updated  Nov 26 2019
3 Replies

Showing an error message with error code DVF 0008, went thru all troubleshooting message. it continues with system failure. Do we need to send out for maintenance.

RE: Nanosonics - Trophon EPR
Updated  Mar 10 2019
1 Reply

I turn on the equipment and the warm up process begins. before it completes the process I get an error message of DGW8028 can someone tell me what this error means?

RE: Nanosonics - Trophon EPR
Updated  Jan 3 2019
2 Replies

Does anyone have a service manual? I am getting error code NL01. Thank you

RE: Nanosonics - Trophon EPR

Start a Thread

Equipment Name: Nanosonics - Trophon EPR
SIGN IN FIRST
This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Please review our Privacy Policy for more details.
I Agree