technical service manual
RE: Mobile C-Arm Report Post
MedWrench is available to help people with specific questions and troubleshooting problems. Could you please be more specific with the issue that you are having with your instrument , and the MedWrench team will do their best to assist you in solving the issue. This will also help other community members who face similar challenges.
Report Post
When the equipment is turned on, it performs the test but does not finish it, and the error 1334 exits and it locks
Report Post
01334 Error
"Please turn the system off, wait 1
minute, and then restart the system.
If this message persists, call for service.
Code:01334"
Can not find WKS communication in 4
minutes after MCB boot up.
Jamison Ashby, MBA
Owner: Precision Imaging solutions
www.PI.solutions
Report Post
I would try reloading software
Jamison Ashby, MBA
Owner: Precision Imaging solutions
www.PI.solutions
Report Post
can any one help me to send me a service password and also a service manual because i have an issue on spine expose i need a callibration
Report Post
Dear Sir
can any one help me to send oec 850 service manual and service password its requst i need please help me naturalypolite@gmail.com
Report Post
Good Day
Appreciate if snyone can share the Service Manual and Servie Password of Brivo OEC 850. Need to chenge CMOS Battery and to perform calibration.
Regards,
Serge
Report Post
When the equipment is turned on, it performs the test but does not finish it, and the error 1307
"Please turn the system off, wait 1
minute, and then restart the system.
If this message persists, call for service.
Code:1307
what we can do to solve this problem
thx
Report Post