Advertisement
Home > Q&A > OEC 6800 Error
Advertisement
Thu Oct 12 2017

OEC 6800 Error

- no signal fatal error Anyone seen it before?
Report Post
Sat Oct 14 2017Reply from www.PI.solutions
www.PI.solutionsReplacing the Image Processor board fixed the problem.

Jamison Ashby, MBA


Owner: Precision Imaging solutions


www.PI.solutions


Report Post
Thu Oct 12 2017Reply from www.PI.solutions
www.PI.solutions

Hey, we happened to have another cpu board. Same error.



Jamison Ashby, MBA


Owner: Precision Imaging solutions


www.PI.solutions


Report Post
Thu Oct 12 2017Reply from Rad Rays LLC
avatar placemark

Please contact us at Rad Rays (410) 737-4404 and we can quote you on a replacement CPU board. Thanks


Report Post
Thu Oct 12 2017Reply from www.PI.solutions
www.PI.solutionsReseated all the boards

Jamison Ashby, MBA


Owner: Precision Imaging solutions


www.PI.solutions


Report Post
Thu Oct 12 2017Reply from Rad Rays LLC
avatar placemark

Try reseating the CPU board first. It is the third board from the left in the workstation cage.


Report Post
Thu Oct 12 2017Reply from www.PI.solutions
www.PI.solutions

Yes with an external monitor watching the boot up process



Jamison Ashby, MBA


Owner: Precision Imaging solutions


www.PI.solutions


Report Post
Thu Oct 12 2017Reply from Rad Rays LLC
avatar placemark

Is this on an external VGA monitor? 


Report Post
Thu Oct 12 2017Reply from www.PI.solutions
www.PI.solutions

It's on boot up actually says no frame sync fatal error



Jamison Ashby, MBA


Owner: Precision Imaging solutions


www.PI.solutions


Report Post
Thu Oct 12 2017Reply from Rad Rays LLC
avatar placemark

Where exactly are you seeing this error message? 


Report Post

For questions about using the MedWrench web site:

(866) 989-7057TOLL FREE  •  (770) 692-8371INTERNATIONAL

support@medwrench.com

MedWrench is in association with:

TechNationMedical DealerOR TodayMD Expo


Testimonials  •  Advertising  •  Privacy Policy  •  Terms and Conditions

© 2017 MedWrench, LLC. All Rights Reserved