Sun Feb 07 2021

Calibration procedure

Calibration procedure for 6550 scale

   RE: Scales Report Post
Wed Feb 10 2021Reply from Chris S
Chris S

The full calibration procedure is in the service manual under documents on the left side of this webpage.

D. Calibration

1. With the MV1 on, press and hold the calibration switch until the display changes to show: SEtuP.

2. Release the calibration switch.

3. During setup and calibration, pressing the ENTER key will cause the data displayed, to be retained and the indicator will advance to the next prompt. Change the value by entering the new data by the numeric keypad then press the ENTER key.

4. Follow prompts (see calibration table)


Official MedWrench Guru
Report Post

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Please review our Privacy Policy for more details.
I Agree