hey, guys. so, this 9600 boots up and takes x-ray but the left monitor doesn't show anything when trying to figure it out , the right monitor went out. now both monitors don't show anything. I open them up and notice there is no orange "glow" in the the bulbs that show when there's power in them. I swap out the the 2 power supplies that are in the workstation, the power control board, a different monitor, the J9 cable and I'm still not getting anything . does anybody have any ideas?
Fri May 06 2022
monitors not working
Fri May 06 2022Reply from C12Guy
do you have video out the rear BNC?
Going backwards then you can look at the video output from the high rate scan converter pcb then the image processor. video output from the video switching pcb
Report Post
Thu May 19 2022Reply from Medical Tech
thanks. if, anyboday has smilar follow c12guy advice. go backwards. scan coverter was issue
Report Post