Over the weekend, I replaced the X belt. Upon completing the installation, we discovered that the table centering wasn't operational; it only moves in one direction. The daily check also fails, and when the phantom is placed, the table doesn't center and displays error 27. I attempted motor TX calibration, which saved the values, but the issue persists. Is there anyone who can assist me in resolving this?
Tue Aug 15 2023
Daily start test and lock centering are not functioning
Tue Aug 15 2023Reply from denis goncalves
Tue Aug 15 2023Reply from DEXA Solutions
Wed Aug 16 2023Reply from Emily Vitkovitsky
If you are in need of immediate assistance please feel free to reach out directly to our sponsors. They are happy to help.
Just be sure to tell them you were referred by MedWrench
Report Post
