This morning the ultrasound tech completed for study without issue. Bed elevated/lowered without issue.
When second patient on table, the bed will not change position in response to selection of any buttons on the control. We hear a beep each time make a selection.
Have unplugged bed for more than one minute. Plugged back in . Still not working.
All cords seen in good working order and securely in place.
The ultrasound table is an "Oakworks general with fowler"
Thoughts/Suggestions?
Not successful. There is a break along the cord going from hand control to bed. I am able to manipulate and isolate the area. Hand control beeps pending bend in the cord.
Thus needless to say we are looking for a replacement bed control device.
Have called Oakworks and their distributors. Because bed is 10 year old, no one makes replacement parts for this bed. Do you know of a source that might have one?
We will ultimately replace the sonography table.
Thank you for your assistance.
Regards, Michel.
C. Michel Bessette, RRT (Canada #72-659)
Servicios Tecnicos CMB7
Ottawa, Canada K4A 1L4
serviciostecnicoscmb7@gmail.com
Registered Respiratory Therapist (Canada #72-659)
Bio-Medical Technological Services: Compressed Gas Systems Specialist
Anaesthesia & Hyperbaric Chamber Technologist
Services in: English, Français & Español
Thank you Michael.
RPI does not carry this brand of equipment/parts but thank you for the link. I am keeping for future reference.
For what its worth, Oakworks does not manufacture replacement parts/service equipment after 7 years.
Regards,
Jane
pull it apart, hoe many conductors in the cable, can easily order a new S-cord form any electrical supplier and then solder, crimp, reattach the ends
