I'm getting an error code on a Siemens Cios Select. It’s still taking images, but after each image, it is showing “err 10” on the base of the c-arm where it normally displays the angle and p/s. Any ideas?
Sat Aug 24 2024
Err 10 code
Sun Aug 25 2024Reply from escamuchero
Sun Aug 25 2024Reply from escamuchero
Wed Aug 28 2024Reply from Emily Vitkovitsky
If you are in need of immediate assistance please feel free to reach out directly to our sponsors. They are happy to help.
Just be sure to tell them you were referred by MedWrench
Report Post
Wed Aug 28 2024Reply from The Ziehm Guy
Good Morning Emily. Yes, Surgi-Call is here to help with your c-arm needs, however, Surgi-Call specializes in Ziehm and OrthoScan c-arms. Apologies for the confusion.
Report Post
