Wed May 15 2013

HDD reformat

I have a new HDD for a Logiq 400 destined for a unit in Afghanistan. We are attempting to copy the known good software from a HDD to another to send it along. We are not able to read the format of the working HDD to allow us to clone or copy. It is not EXT3, FAT or NTFS. Any ideas? Your help is greatly appreciated. Ron.

RE: Ultrasound Systems Report Post

Rick Reed

Wed May 15 2013Reply from Rick Reed

This system uses the pSOS+ operating system...not DOS.

Best is a preloaded drive as a replacement.

You can try a "bit by bit" cloning s/w or hardware (drive to drive).

check section 6-4 of L400 svc manual for some tips.

Rick Reed

ULTRASOUND SPECIALIST Rick Reed, BSET Owner/Senior System Engineer Precision Medical Ultrasound POBox 6308 Lubbock, TX 79493 rick@pmultrasound.com www.pmultrasound.com Tel:806-686-4586 REPtrax ID:365419 ULTRASOUND PM/QA INSPECTIONS REPAIR and Service Training

Report Post

Ron Morey

Thu May 16 2013Reply from Ron Morey

Rick, thanks for the advice. We will check it out. Ron.

Report Post

Ron Morey

Thu May 16 2013Reply from Ron Morey

Rick, thanks for your help. Ron.

Report Post